Mathews Chill SDX Mod Chart

Need a new set of Mathews Chill SDX Mods to get your hunting bow set to your draw length? Use our handy Mathews Chill SDX Mod Chart below.

Designed for short draw arhcers, the Chill SDX is 30.55″ ATA compound bow rated for 330 feet per second. Because of this, it is slightly slower than the Chill R, despite sporting the same 6″ brace height.

Draw length ranges from 23″ to 29″ and draw weight ranges from 30 to 70 pounds. This is ten pounds lower and an inch shorter than any of the other McPherson Chill Series bows.

The Mathews Chill SDX was discontinued in 2017. So if you purchase a used Mathews Chill, you may need to change the draw mods to fit your draw length.

The Chill SDX utilizes Mathews Archery’s DYAD cam. Rock mods are available in both 85% and 75% let off. Fine tune your bow to the perfect settings. Achieve the perfect draw length and exact holding weight you’re after.

Visually, the 75% Chill rock mods are silver and the 85% rock mods are black. Mathews makes it easy to differentiate between the two.

Mathews Chill SDX Mod Chart

Wrong Mathews Chill Mod Chart? See our other Chill mod charts for Mathews Rock Mods:

Mathews Chill SDX Mod Chart

Mod LetterChill SDX Draw Length85% Let Off Part No.75% Let Off Part No.
A29″50750A50890A
B29.5″50751A50891A
C29″50752A50892A
D28.5″50753A50893A
E28″50754A50894A
F27.5″50755A50895A
G27″50756A50896A
H26.5″50757A50897A
I26″50758A50898A
J25.5″50759A50899A
K25″50760A50900A
L24.5″50761A50901A
M24″50762A50902A

Mathews Chill SDX Mod Chart

Rock Mods for the Mathews Chill SDX are available at your nearest Mathews Archery dealer. Just give them the part number from our Mathews Chill SDX mod chart above. Unlike other companies, Mathews Archery keeps parts readily available for every compound bow they have ever produced. This makes it simple to maintain your bows even if something happens to go wrong. Visit the Mathews Archery website to find a dealer near you.

Additional Mathews Mod Charts Available

Leave a Comment

Your email address will not be published. Required fields are marked *